From Wikipedia, the free encyclopedia - View original article
|Release date||April 3, 1981|
|CPU||Zilog Z80 at 4.0 MHz|
|This article's lead section may not adequately summarize key points of its contents. (August 2014)|
|Release date||April 3, 1981|
|CPU||Zilog Z80 at 4.0 MHz|
The Osborne 1 was the first commercially successful portable microcomputer, released on April 3, 1981 by Osborne Computer Corporation. It weighed 10.7 kg (23.5 lb), cost $1,795 USD, and ran the CP/M 2.2 operating system.
The computer shipped with a large bundle of software that was almost equivalent in value to the machine itself, a practice adopted by other CP/M computer vendors.
Competitors such as the Kaypro II that used double sided drives and larger 9" screens that could hold a full 80x25 display quickly appeared.
The Osborne 1 was developed by Adam Osborne and designed by Lee Felsenstein. It was first announced in early 1981. Osborne, an author of computer books, decided he wanted to break the price of computers.
The Osborne's design was based largely on the Xerox NoteTaker, a prototype developed at Xerox PARC in 1976 by Alan Kay. The computer was designed to be portable, with a rugged ABS plastic case that closed up and a handle. The Osborne 1 was about the size and weight of a sewing machine and was advertised as the only computer that would fit underneath an airline seat. It is now classified as a "luggable" computer when compared to later laptop designs such as the Epson HX-20.
Despite its unattractive design and heavy weight—the Osborne 1 reportedly resembled "a cross between a World War II field radio and a shrunken instrument panel of a DC-3", and Felstenstein confessed that carrying two units four blocks to a trade show "nearly pulled my arms out of their sockets"—the computer amazed observers. BYTE wrote, "(1) it will cost $1795, and (2) it's portable!" ($1795 is the equivalent of $4656 today.) The bundled word processing, spreadsheet, and other software alone was worth $1,500; as InfoWorld stated in an April 1981 front-page article on the new computer after listing the included software, "In case you think the price printed above was a mistake, we'll repeat it: $1795."
Osborne claimed that the new computer had a "significant price/performance advantage" but emphasized the price, stating that its performance was "merely adequate": "It is not the fastest microcomputer, it doesn't have huge amounts of disk storage space, and it is not especially expandable." Beyond the price, advertisements emphasized the computer's portability and bundled software. In the first eight months after April 1981, when the Osborne 1 was announced, the company sold 11,000 units. Sales at their peak reached 10,000 units per month.
Its principal deficiencies were a tiny 5-inch (13 cm) display screen and use of single sided, single density floppy disk drives which could not contain sufficient data for practical business applications, and considerable unit weight. Adam Osborne had made the decision to use single-sided drives because he was concerned that double-sided units could not tolerate rough handling. A single density disk controller was used to keep costs down. As a result, the Osborne's floppy disks held a mere 90k.
In September 1981, Osborne Computer Company had its first US$1 million sales month. Sales of the Osborne 1 were hurt by the company's premature announcement of superior successor machines such as the Osborne Executive, a phenomenon later called the Osborne effect.
From 1982 to 1985 the company published The Portable Companion, a magazine for Osborne users.
I can confirm that this is one of the first ten prototype units built, known as the "metal case" units. I don't think they had serial numbers. The cases were made by Galgon Industries in Hayward, California but their quote for production was prohibitive, so work immediately commenced on the plastic cases. The circuit board was ready in January 1981 and these were built shortly thereafter. They were used in the first ads ("the guy on the left doesn't stand a chance") in which the veins on the hand of the guy on the right bulge as he struggles with the 30-pound weight of his transformer-powered luggable. These were the units we took to the West Coast Computer Faire and the National Computer Conference in early 1981.
The computer was widely imitated as several other computer companies began offering low-priced portable computers with bundled software. The Osborne's popularity was surpassed by the similar Kaypro II which had a much more practical 9 inches (23 cm) CRT that could display the standard 80 characters on 24 lines as well as double density floppies that could store twice as much data. Osborne Computer Corporation was unable to effectively respond to the Kaypro challenge until after the market window had closed and the day of the 8-bit, CP/M-based computer had ended.
In 1981, IBM released the 16-bit IBM PC which was significantly more powerful and expandable than 8-bit computers of the day. Following the release of the IBM-compatible Compaq Portable in 1983, the market for CP/M computers quickly plummeted and Osborne was unable to compete.
The Osborne Computer Company announced a successor to the Osborne 1 in 1982, the Executive model OCC-2 and in early 1983, the company announced the more advanced Osborne Vixen,. This was a smaller machine with the keyboard permanently attached, which also acted as a stand. However, unable to beat its competition in the marketplace, Osborne Computer Corporation filed for bankruptcy in September 1983. It released the Osborne-4 (Vixen) in 1985, but it did not sell in great numbers.
Main memory was eight rows of model 4116 16,384 x 1-bit dynamic RAM chips, shared between CPU memory and video memory. No parity was provided and no provision for memory expansion existed on the motherboard. The boot program loader and significant parts of the BIOS were stored in a 4 kilobyte EPROM, which was bank-switched. A second EPROM was used as a fixed character generator, providing upper and lower case ASCII characters and graphic symbols; the character generator was not accessible to the CPU. The eighth bit of an ASCII character was used to select underlined characters. Serial communications was through a memory-mapped Motorola MC6850 Asynchronous Communications Interface Adapter (ACIA); a jumper on the motherboard allowed the MC6850 to be set for either 300 and 1200 baud or 600 and 2400 baud communications, but other bit rates were not available.
The floppy disk drives were interfaced through a Fujitsu 8877 disk controller integrated circuit, a second-source of the Western Digital 1793. The parallel port was connected through a memory-mapped Motorola MC6821 Peripheral Interface Adapter (PIA) which allowed the port to be fully bidirectional; the Osborne manuals also claimed the port implemented the IEEE-488 interface bus but this was rarely used. The parallel port used a card-edge connector etched on the main board, exposed through a hole in the case; any IEEE-488 or printer cable had to be specially manufactured for the Osborne.
The disk drives used either Siemens or MPI full-height single-sided drive mechanisms, but the drive electronics board was replaced by an Osborne-designed board, which allowed both power and signal connections to be carried on the same ribbon cable from the motherboard. The power connections used lines that standard drives reserved for ground.
The video system used part of the main memory and TTL logic to provide video and synch to an internal 5-inch monochrome monitor. The same signals were provided on a card edge connector for an external monitor; both internal and external monitor displayed the same video format.
The Osborne 1 came with a bundle of application software with a retail value of more than US$1500, including the WordStar word processor, SuperCalc spreadsheet, and the CBASIC and MBASIC programming languages. The exact contents of the bundled software varied depending on the time of purchase; for example, dBASE II was not included with the first systems sold.
|Program Name||Version||Published by||Program Type||Date||Part Number||Number|
|CP/M||2.2||Digital Research||Disk Operating System|
|CBASIC2||Digital Research||Language compiler||1979|
|dBase II Tutor||Ashton Tate||Training for database||6|
|Nominal Ledger||2.7||PeachTree Software||Business Software||1983||2X09200-04||2|
|Purchase Ledger||2.7||PeachTree Software||Business Software||1983||2X09200-04||2|
|Sales Ledger||2.7||PeachTree Software||Business Software||1983||2X09200-04||2|
The Osborne 1 was powered by a wall plug with a switched-mode power supply, and had no internal battery, although an aftermarket battery pack offering 1-hour run-time was available. Early models (tan case) were wired for 120 V or 240 V only. Later models (blue case, shipping after May 1982) could be switched by the user to run on either 120 V or 230 V, 50 or 60 Hz.
Additional peripherals were available by different third-party vendors at various times during the life of the Osborne 1.
A small set of aftermarket vendors offered several other upgrades to the basic model, including third-party double density disk drives, external hard disks, and a battery-backed RAM disk that fit in a disk storage compartment.
The Osborne corporation offered a "Screen Pac" 80-column upgrade that could be switched between original 52 column and 80 column modes. Osborne 1 systems with the 80-column upgrade have an RCA jack installed on the front panel to allow users to connect an external composite video monitor. This modification was developed in Australia by Geoff Cohen and Stuart Ritchie both of whom worked with the Company to implement the mod.
Since, like most CP/M systems, the display of the Osborne did not support bit-mapped graphics, games were typically character based games, like Hamurabi or text adventures (the 1982 game Deadline, for example, packaged in a dossier type folder and came on two 51⁄4" diskettes.). Compiled and MBASIC interpreted versions of Colossal Cave Adventure were available for the Osborne. Some type in games made good use of the Osborne's limited character-mode graphics.
Jerry Pournelle wrote that the small size of the Osborne's screen surprised him by not being a problem, and stated that after using it at Caltech when Voyager 1 arrived at Saturn, "a dozen science writers were ready to go buy an Osborne 1". He added, "I was able to type ... without disrupting the meeting at all. The Osborne 1 is quiet and efficient and not at all distracting ... You can't beat it for the price, under $2000 bucks with over a thousand dollars' worth of software. An Osborne and an Epson printer will put you in the computing/word-processing business cheaper than anything I can think of". BYTE stated "If you need a solid, well-supported, well-documented business system at a reasonable price, you should give [the Osborne 1] a great deal of consideration". The reviewer calculated that after subtracting $1530 for the retail price of the bundled software the price of the computer was "only $265", praised the quality of the documentation, and agreed with Pournelle that the screen's size did not cause difficulty.
The Osborne one personal computer is the first personal computer to have been deployed in a military field operation. The system was used to perform patient administration operations and laboratory operations for the 28th Combat Support Hospital, 44th Medical Brigade. System implementation by 1LT Michael Dohm, operation and management by SGT Christopher Otto.