From Wikipedia, the free encyclopedia - View original article
A chiclet keyboard, or island-style keyboard, is a type of computer keyboard that uses keys in the shape of small squares with rounded corners, in the style of Chiclets gum. Each key is surrounded by a perforated plate which holds it in position, so that there is a space between the keys.
The keys on Sinclair ZX Spectrum computers were "rubber dome keys" which were sometimes described as "dead flesh", while the TRS-80 Color Computer, TRS-80 MC-10, and Timex Sinclair 2068 were all described as having "chiclet keys". The feel of the IBM PCjr's chiclet keyboard was reportedly compared to "massaging fruit cake"; its quality was so poor that an amazed Tandy executive, whose company had previously released the Color Computer with a similarly unpopular keyboard, asked "How could IBM have made that mistake with the PCjr?"
The term has changed meaning in recent years, and is now used to describe low-profile, low-travel scissor keyboards with simplified, flat keycaps separated by a bezel. Sony was the first modern laptop manufacturer to make use of this keyboard style with the release of the VAIO X505 in 2004. Apple was likewise among the first to change the design of its keyboards to the chiclet style, with the release of the MacBook in 2006, and is credited with popularizing the style.
In some versions of the chiclet keyboard, the bottom three layers are essentially the same as those in the membrane keyboard. In both cases, a keypress is registered when the top layer is forced through a hole to touch the bottom layer. For every key, the conductive traces on the bottom layer are normally separated by a non-conductive gap. Electrical current cannot flow between them; the switch is open. When pushed down, conductive material on the underside of the top layer bridges the gap between those traces; the switch is closed, current can flow, and a keypress is registered.
Unlike the membrane keyboard, where the user presses directly onto the top membrane layer, this form of chiclet keyboard places a set of moulded rubber keys above this. With some key designs, the user pushes the key, and under sufficient pressure the thin sides of the rubber key suddenly collapse. In other designs — such as that seen in the diagram — the deliberate weak point is where the key joins the rest of the sheet. The effect is similar in both cases.
This collapse allows the solid rubber center to move downwards, forcing the top membrane layer against the bottom layer, and completing the circuit.
The "sudden collapse" of the chiclet keyboard (along with the movement of the key) provides a greater tactile feedback to the user than a simple flat membrane keyboard.
Other versions of the chiclet keyboard omit the upper membrane and hole/spacer layers; instead the underside of the rubber keys themselves have a conductive coating. (This is the type shown in the photograph of the remote control, above). When the key is pushed, the conductive underside makes contact with the traces on the bottom layer, and bridges the gap between them, thus completing the circuit. Grooves between hollow domes on the blue underside permit air to flow out of a dome when a key is pressed, and let air come back in when released.
The dome switch keyboards used with a large proportion of modern PCs are technically similar to chiclet keyboards. The rubber keys are replaced with rubber domes, and hard plastic keytops rest on top of these. Because the keytops are wider than the rubber domes the keytops are not separated but align almost perfectly with only a minimal gap in between each other.
|This article may contain excessive, poor, or irrelevant examples. (January 2010)|
All of the computers listed hail from the early home computer era, except the OLPC XO-1.