From Wikipedia, the free encyclopedia - View original article

A **bridge circuit** is a type of electrical circuit in which two circuit branches (usually in parallel with each other) are "bridged" by a third branch connected between the first two branches at some intermediate point along them. The bridge was originally developed for laboratory measurement purposes and one of the intermediate bridging points is often adjustable when so used. Bridge circuits now find many applications, both linear and non-linear, including in instrumentation, filtering and power conversion.^{[1]}^{[2]}

The best-known bridge circuit, the Wheatstone bridge, was invented by Samuel Hunter Christie and popularized by Charles Wheatstone, and is used for measuring resistance. It is constructed from four resistors, two of known values R_{1} and R_{3} (see diagram), one whose resistance is to be determined R_{x}, and one which is variable and calibrated R_{2}. Two opposite vertices are connected to a source of electric current, such as a battery, and a galvanometer is connected across the other two vertices. The variable resistor is adjusted until the galvanometer reads zero. It is then known that the ratio between the variable resistor and its neighbour R1 is equal to the ratio between the unknown resistor and its neighbour R3, which enables the value of the unknown resistor to be calculated.

The Wheatstone bridge has also been generalised to measure impedance in AC circuits, and to measure resistance, inductance, capacitance, and dissipation factor separately. Various arrangements are known as the Wien bridge, Maxwell bridge and Heaviside bridge.^{[3]} All are based on the same principle, which is to compare the output of two potentiometers sharing a common source.

In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity.

In some motor controllers, a H-bridge is used to control the direction the motor turns.

- anderson bridge
- Bridged T circuit
- Carey Foster bridge
- Fontana bridge
- Graetz bridge
- Hay bridge
- Kelvin bridge
- Lattice filter
- Maxwell bridge
- Murray loop bridge
- Owen bridge
- Phantom circuit - a use of balanced bridge circuits
- Resonance bridge
- Sawyer-Tower bridge
- Schering bridge
- Wheatstone bridge
- Wien bridge

**^**Bureau of Naval Personnel,*Basic Electricity*, p.114, Courier Dover Publications, 1970 ISBN 0-486-20973-3.**^**Clarence W. De Silva,*Vibration monitoring, testing, and instrumentation*, pp.2.43-2.49, CRC Press, 2007 ISBN 1-4200-5319-1**^**All about circuits: AC bridge circuits

- Jim Williams, "Bridge circuits: Marrying gain and balance", Linear Technology Application Note 43, June 1990.
- Bridge circuits - Chapter 8 from an online book.
- Wien, Shering, Hay, Owen, Maxwell, and Resonance Bridges
^{[dead link]}- With balance equations